Today we tested and inspected some new equipment for bonding. We received a not so positive result. The glue on the surface of the SFB (it is a special textile material) was not sufficient. There were gaps on both sides of the joint between panels. Therefore, the settings of the ABM (it is a special machine for gluing the SFB to the panel) must be configured differently. For example: the distance between the nozzles must be corrected, the hotpot (it is a plate which heats the surface of the SFB for solidiying glue more quickly) does not press on the surface of SFB enough. We will waste a lot of time in the real working condition, because we will configure equipment in the tank. In my point of view we need to set up them in the bonding school. I am really afraid to exceed the deadline of the approved schedule.